Shutdown

⚠️ Only for use by or with the express permission of the Technical Director ⚠️ In the event an emergency shutdown is required, the Technical Director should be consulted with first.

  1. In Studio 1, on PC PURE-S1-01, stop PlayIt Live playing out using the red stop button then mute all channels on the Studio 1 sound desk.
  2. Shut down PC PURE-S1-01
  3. Turn off the Wholer at the plug on the wall
  4. In the server rack, mute all channels on the TX mixer
  5. Login to Proxmox, using the root account, from PURE-S1-02
    1. Then select paulogrady in the left-hand-side Datacentre menu
    2. Then click the Shutdown button in the top right hand corner
    3. Wait for the output shown at the bottom of the screen to show that VM 100 and VM 102 have shutdown.
  6. Login to the Netgear NAS’ web interface and shut that down using the power icon in the top right hand corner
  7. SSH into the Blackbox (jackhayes) - note you’ll need to use it’s IP address as DNS will be broken by this point
    1. Enter the command sudo shutdown now to shut it down
  8. SSH into the LibreTime Server (nelshylton) - not you’ll need to use it’s IP address as DNS will be broken by then
    1. Enter the command sudo shutdown now to shut it down
  9. Shutdown PC PURE-S1-02
  10. Turn off and unplug PC monitors and mood lighting in Studio 1
  11. Turn off and unplug in the following order, in Studio 1:
    1. Monitoring Speakers
    2. PURE-S1-01 and PURE-S1-02
    3. Compressors
    4. Sound Desk
  12. Shutdown Studio 2 PC PURE-S2-01
  13. Move into the server room, you may find it easiest to roll the Large OB kit out of the server room and into Studio 2 to make space; unlock the Server Rack if you haven’t done so already.
  14. Press the power button on claraamfo to shut that down. It might try to start up again, if it does this - press & hold the power button again
  15. Press the power button on the router and it should beep then turn off
  16. Turn the switch on the IEC PDU to the 0 position
  17. Wait some time
  18. Turn off the switch on the Type-G PDU
  19. Close and lock the rack
  20. Turn off the plug labelled SVR PSU 1
  21. Turn off the plug labelled SVR PSU 2
  22. Turn off the two PDU’s plugs
  23. Unplug all plugs, do not leave them on the floor
  24. Press the power button on the AC unit and wait for it to turn off.